This part was stamped using a GRIPflow® Compound Die. The material is a low carbon hot rolled steel (SAE 1008/1010). The material thickness is 0.212”. Hole “A” shows 1 of 4 holes that are 0.098” +/- 0.001” (approximately 46% of the material thickness). Section “B” shows 1 of 2 small web-sections that are 0.064” (approximately 30% of the material thickness). All six holes were pierced in the GRIPflow® Compound die. The part is used in a “hard disk drive” assembly within the Computer Industry. GRIPflow® was an economical alternate to drilling the six holes.